• After performing the solution, it is recommended to perform the color calibration of the external
controller.
• Check the toner fusibility as follows:
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if it is rubbed by the cloth for cleaning the contact glass.
Poor output of Metallic Papers and Synthetic Papers
Printing on metallic or synthetic papers can lead to the following problems.
• Paper curling
• Not stacked properly
• Paper jams
• Folded edges
Cause:
Curling may occur due to differences in the fusing and pressure application temperatures. Paper output
during post-processing may also fail to occur properly.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
1. Load the sheets the other way up.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. In the printer settings, change the paper to be output in face up.
4. Print the image. Has the problem been resolved?
Yes Finished!
Other Post- Processing Options
313
To Next Page
Loading...
