If you use this method, calibration updates only the calibration setting that is used to print this job.
Creating a new calibration set
1. Creating a new calibration set, create a name for it and click [Next].
2. Enter a calibration name and an optional comment, and then click [Next].
3. Select a device, and then click [Print].
If using the automated inline sensor
Select the [Automated inline sensor], and then check that [Calibration] is selected in the "Patch
set" list.
If using the optional ES-2000
Select [EFI ES-2000].
4. Configure the settings for the paper, and then click [OK].
5. Measure using ES-2000, and then apply the measurement values.
• The color reproducibility may be improved after executing 0506: [Execute Developer Refreshing]
in the [Machine: Maintenance] group on the [Adjustment Settings for Operators] menu.
• After this procedure is repeated three times, the difference between each color's [D-Max] value in
the measurement column and that in the target column may not be equal to +0.3 or lower and -0.3
or higher for cyan, magenta, and black, or +0.1 or lower and -0.1 or higher for yellow. If this is the
case, print solid images on both sides of 100 sheets of A4 or LTR paper continuously. Desired
results may be obtained.
• If the difference between each color's [D-Max] value in the measurement column and that in the
target column may not be equal to +0.3 or lower and -0.3 or higher for cyan, magenta, and black,
or +0.1 or lower and -0.1 or higher for yellow, color reproducibility may be improved after
printing solid images on both sides of 100 sheets of A4 or LTR paper continuously.
11. Advanced Instructions
322
To Next Page
Loading...
