• After sliding the paper tray in, make sure that the paper size is changed correctly on the [Top]
screen. To display the [Top] screen, display the [Home] screen and press the icon at the upper
right corner of the screen.
• You can load envelopes in Trays 1, 2, and the wide LCT. When loading envelopes, place them in
the correct orientation. For details, see page 132 "Envelopes".
• Do not push in the paper presser on the upper part of the side fence. If it is pushed in, return it to its
original position by hand.
1. Paper presser
• When you load paper that is 420.0 mm (16.54 inches) or wider in the banner sheet tray of the
wide LCT, load it as follows:
• Press the elevator switch to move the bottom plate down until the lamp goes out, and then
open the cover and load the paper.
• Hold the paper lengthwise and load it little by little.
• If you load thin paper or coated paper, load it little by little. Press down on the paper while
you load it so that the paper loaded in the bottom is not dragged.
• If you load thick paper, load it little by little and align the side fence with the horizontal side of
the paper.
• Check that the paper is correctly positioned against the back of the paper tray and the label
on which is printed the paper sizes for the paper tray.
• When you load paper that is 420.0-559.9 mm (16.54–22.00 inches) wide, use two short-
end fences.
Changing the Paper Size
113
To Next Page
Loading...
