Problem Cause Solution
Misfeeds occur frequently. The tray's side or end fences
may not be set properly.
• Remove the misfed paper. For
details about removing jammed
paper, see page 243 "Removing
Jammed Paper".
• Check that the side or end fences
are set properly. Also, check that
the side fences are locked. For
details about setting the side and
end fences, see page 109
"Changing the Paper Size".
Misfeeds occur frequently. Paper of undetectable size
has been loaded.
• Remove the misfed paper. For
details about removing jammed
paper, see page 243 "Removing
Jammed Paper".
• If you load a paper size that is not
selected automatically, you need
to specify the paper size with the
control panel. For details about
specifying paper size using the
control panel, see page 116
"Changing to a Size That Is Not
Automatically Detected".
Misfeeds occur frequently. There is a foreign object on
the output tray.
• Remove the misfed paper. For
details about removing jammed
paper, see page 243 "Removing
Jammed Paper".
• Do not place anything on the
output tray.
Misfeeds occur frequently. The staple cartridge is not set
correctly.
Set the staple cartridge properly. For
details about how to add staples, see
page 272 "Adding Staples".
Getting Started
233
To Next Page
Loading...
