8. Remove the two lower screws that secure the carriage cover.
Use the removed screws when reattaching. Be sure to store them in a safe place.
9. Loosen the two upper screws, and then remove the carriage cover.
Use the removed cover when reattaching. Be sure to store it in a safe place.
10. Loosen the screw that secures the port cover of the print head used for air purging, and
then remove the port cover.
• Use the removed screw and cover when reattaching. Be sure to store them in a safe place.
• When you replace the displacement liquid with white ink, remove the port cover of print head
2.
• When removing the port cover, avoid contact with parts other than the fixing screw. Failure to
do so may lead to malfunction.
• Remove the port cover by holding the points shown in the illustration below. Do not pull the
tab that is on the top of the port cover.
When You Cannot Print as Expected
191
To Next Page
Loading...
