1. The port cover for print head 1
2. The port cover for print head 2
3. The port cover for print head 3
11. Hook the air purge tool over the front of the carriage.
Check that the air purge tool is correctly set on the edge of the front of the carriage.
12. Raise the lock lever located inside of the right cover on the left, and then close the right
cover.
13. Press [Execute].
Ink is discharged in the air purge tool. Wait until a completion message appears on the control
panel.
14. Open the right cover.
5. Troubleshooting
192
To Next Page
Loading...
