13. Insert the tip of the media between the feed rollers and pinch rollers.
• If the media is difficult to insert because the edges of the media are getting caught, diagonally
insert the media between the rollers, so that one corner gets inserted first. Ensure the media is
inserted evenly, and begin feeding.
• Holding the edge of the media, adjust the angle at the leading edge of the media and load it.
• If there is no media on the sensor, the machine cannot detect media successfully. Set media so
that it covers the media sensor on the left side of the feeding surface.
• Withdraw the media approximately one hand grip's worth from the media feeding surface on
the front of the machine.
Setting Media
57
To Next Page
Loading...
