• If the edge of the media is out of the range of the pre-heater's scale, release the roll holder's
holding lever, and then adjust the roll holder's position.
• Align the edge of the media, and then load the media while adjusting media position by hand
so that it is stretched evenly. It helps to load the media evenly by holding the flange or edge of
the media and controlling the roll media's rotation. When you do this, check scale indicating
the edge of the media.
14. While holding down the center of the media, lower the media holding lever (back).
The pinch rollers lower and the media is fixed.
15. Return the pre-heater cover to its original position.
• After returning the pre-heater cover to its original position, press its ends to make sure that it is
not bulging.
• If you operate the device with a bulge in the pre-heater cover, the cover may come open
during operation or printing.
16. Open the center cover on the front of the machine.
17. While holding down the center of the media, raise the media holding lever (front).
The pinch rollers rise and the media is unfixed.
2. Basic Operations
58
To Next Page
Loading...
