1.Detailed Descriptions
2
1. Detailed Descriptions
Changes from the Previous Machine
• Antistatic Control
Metal cover [A] for antistatic control has been added to the following sensors:
• Paper Feed Sensor
• Transport Sensor
• Paper End Sensor
When replacing the those sensors, this cover will also be used after replacement, so remove it from the
old sensors. When you do so, be careful not to deform or damage anything.
1: Paper Feed Sensor
2: Upper Limit Sensor
3: Paper End Sensor
4: Transport Sensor
• Dehumidification Heater
An optional dehumidification heater (attached to the side of the tray) is available.
To Next Page
Loading...
