2. IPv4
You can change the IPv4.
3. IPv6
You can change the IPv6.
4. SNMP
You can change the SNMP.
5. Administrator Settings
You can change the administrator password.
6. Restore Defaults
You can reset the administrator password and other network settings.
7. Machine Information
The machine information appears.
Changing the Machine Settings
To change the machine settings, log in to the machine as the administrator.
1. Launch the Web browser.
2. In the address bar, enter "http://(machine's IP address)/".
3. Click [Log in].
4. Enter the administrator password, and then click [Log in].
If you are logging in for the first time, enter "admin133" as the password.
5. In the menu area, select the setting you wish to specify.
6. Specify the machine settings.
7. Click [OK].
The specified settings are transmitted to the machine.
Settings List
This section explains the Web Image Monitor settings.
Checking the System Information
On the top page, you can check the current system information such as the device information, paper
tray status, toner status, and total counter.
4. Configuring the Machine Using Utilities
36
To Next Page
Loading...
