To make the [Shortcut to Func.] key enable ID card copy mode for the current job, [Shortcut to
Function] under [Admin. Tools] must be set to [ID Card Copy Mode]. You can also assign the
setting using Web Image Monitor.
For [Shortcut to Function], see page 206 "Administrator Settings".
2. To make multiple copies, enter the number of copies using the number keys.
3. Place the original in the upper-left corner of the exposure glass.
4. Press the [Start] key.
A message prompting you to place the original back side down on the exposure glass appears on
the display.
5. Place the original on the exposure glass with the back side faced down and with the top
to the rear of the machine within the time specified in [System Auto Reset Timer], and then
press the [Start] key again.
• For the ID card copy function, you can set the machine to print a line in the middle of the printed
paper. Specify [ID Card Center Line] under [Copier Features].
• You can change the scanning size for the ID card function. Specify [ID Card Size] under [Copier
Features].
4. Copying Originals
90
To Next Page
Loading...
