Ricoh WG-80 - About the USB Power Adapter

3
Warning
• Always use the USB power adapter exclusively developed for this camera, with
the specified power and voltage. Using a USB power adapter not exclusive to
this camera, or using the exclusive USB power adapter with an unspecified
power or voltage can cause a fire, electric shock, or camera breakdown. The
specified voltage is 100-240V AC.
• Do not disassemble or modify the product. This can cause a fire or electric
shock.
• If the generation of smoke or strange odor from the product or other abnormality
occurs, immediately discontinue its use and consult your nearest service
center. Continued use can cause a fire or electric shock.
• If water should happen to get inside the product, consult your nearest service
center. Continued use can cause a fire or electric shock.
• If you see a lightning flash or hear thunder during use of the USB power
adapter, unplug the AC plug and discontinue use. Continued use can cause
damage to the product, fire, or electric shock.
• Wipe off the AC plug if it becomes covered with dust. Accumulated dust may
cause a fire.
Caution
• Do not place or drop heavy objects on or forcefully bend the USB cable. Doing
so may damage the cable. Should the cable be damaged, consult your nearest
service center.
• Do not touch or short-circuit the terminal area of the USB cable while the cable
is plugged in.
• Do not handle the AC plug with wet hands. This can cause an electric shock.
• Do not subject the product to strong impacts or allow it to drop onto a hard
surface. This can cause a malfunction.
• Do not use the USB power adapter to charge a battery other than a
rechargeable lithium-ion battery D-LI92. This can cause overheating,
explosion, or connected device failure.
•
To reduce the risk of hazards, use only a CSA/UL certified power supply cord set,
cord is Type SPT-2 or heavier, minimum NO.18 AWG copper, one end with a
molded-on male attachment plug cap (with a specified NEMA configuration), and
the other is provided with a molded-on female connector body (with a specified IEC
nonindustrial type configuration) or the equivalent.
About the USB Power Adapter