97
3
Taking Pictures
Set whether or not to turn on the LED Macro Lights around the lens.
The LED Macro Lights turn on when the [Macro Light] is set to O (On), and then
you can use [Brightness] to adjust the brightness.
The default setting is O (On), and Brightness is 1.
1
Use the four-way controller (23) to select [Macro Light] in
the [A Rec. Mode] menu.
The Macro Lights menu appears.
2
Press the four-way controller (5).
A pull-down menu appears.
3
Use the four-way controller (45) to select O (On)/P (Off).
O (On) Turns on the LED Macro Lights
P (Off) Turns off the LED Macro Lights
4
Use the four-way controller (3) to select Brightness, and then
adjust brightness by four-way controller (45).
The setting is saved.
Setting the Macro Light
• The LED does not light even if the LED Macro Light is turned on unless the
Macro Light is set in Flash Mode.
• The shooting modes that is able to select the Macro Light in Flash Mode
are Program, Movie, Report and Digital Microscope. (The macro light
setting is fixed for Digital Microscope.)
• The LED Macro Lights turn off during playback and when using the USB
connector.
• (Self-portrait Assist) and J (Self-portrait Assist + Smile Capture)
cannot be selected when [Macro Light] is set to O (On).
If you take a picture using the self-timer (g, Z) or a remote control unit (h,
i) while [Macro Light] is set to O (On), the LED Macro Lights remain on
regardless of the countdown.
To Next Page
Loading...
