For the most up to date documents, bike models, additional information, instructional videos,
And more visit us at Ride1UP.com
Press and hold UP button for 2 seconds to turn on/off the display backlight and headlights if wired.
5.4 Walk/Push Assist (4mph)
Press and hold DOWN button for 2 seconds enters the walking mode until released.
5.5 Change Settings
Once the eBike is powered on, holding both the UP and DOWN buttons for 2 seconds will access the general
settings. To store the selected settings and exit, hold the MODE button. To cancel the operating and not
store the settings data, hold the DOWN button. This will return you to the previous menu. If there are no
operations in one minute, the display will exit the settings state. The settings can only be accessed when
the eBike is parked.
NOTE: ◆ THE DISPLAY MAY VARY BASED ON GENERATION. PLEASE REFER TO OUR ONLINE
USER MANUAL BASE FOR UPDATED OR PREVIOUS MODELS.
6. Error Code Troubleshooting:
In the event of a problem with the electrical components of your bike, the display will show an error code.
Compare the code with this list below and how to resolve:
• 6.1) Error Codes/Source of the Error:
The battery is not supplying the required voltage to power the
display and motor. Use the display to view the real-time voltage
being output from the battery. It can also be checked using a
multimeter. If the battery is old and has been charged /
discharged many times, it may need to be replaced.
When you press and release the throttle, it should return to the
original position. Remove any obstructions. Check the throttle
and throttle cable for damage, such as a cut or frayed cable.
Check the cable that connects the rear hub motor to the rest of
the system and make sure it is free from grit or contaminants and
is firmly connected. This error might appear if you don’t reconnect
the cable after removing the rear wheel (for example, after
changing a flat tire, or transporting your bike in the trunk of a car).
At least one of the motor wires has been damaged or is
disconnected.
To Next Page
Loading...
