RIDGE RYDER RR50A - Busy Channel Lockout; PTT ID Setup

PAGE 12
FREQUENCY REVERSE/ TALK AROUND OPTION
1. After pressing the “(FUNC) BUTTON”, the top left corner of LCD displays an F icon, then press
“(8SET) BUTTON” to enter function menu.
2. Press “UP ARROW” or “DOWN ARROW” button to choose No.6 function item. It shows
“REV/TA” on LCD
3. Press “(FUNC) BUTTON” to enter into function menu setup.
4. Press “UP ARROW” or “DOWN ARROW” button to select desired setup. REV: The frequency
reverse function is selected. TA: The talk around function is selected.
5. Press “(FUNC) BUTTON” to go back to previous menu. Press “(ESC/M) BUTTON”or “(
*
ENT)
BUTTON” to conrm and exit.
NOTE: After relevant function is selected on current channel, under standby mode, users can press
“(FUNC) BUTTON” and then hold “(
*
T/R) BUTTON” to start chosen function.
BUSY CHANNEL LOCKOUT
BCLO is to disable transmitting while RX signal is received. Once the channel is busy and you press
PTT, the radio will beep as warning and get back to receiving.
1. After pressing the “(FUNC) BUTTON”, the top left corner of LCD displays an F icon, then press
“(8SET) BUTTON” to enter function menu.
2. Press “UP ARROW” or “DOWN ARROW” button to choose No.7 function item. It shows
“BUSY” on LCD.
3. Press “(FUNC) BUTTON” to enter into function menu setup.
4. Press “UP ARROW” or “DOWN ARROW” button to select desired setup. BCL: Enable BCL,
carrier wave lockout, transmitting is prohibited when current channel receives a matching carrier
wave; BTL: Enable BTL, transmitting is prohibited when current channel receives a matching carrier
wave with dis-matching CTCSS/DCS. OFF: Busy Channel Lockout is turned off.
5. Press “(FUNC) BUTTON” to go back to previous menu. Press “(ESC/M) BUTTON”or “(
*
ENT)
BUTTON” to conrm and exit.
PTT ID SETUP
1. After pressing the “(FUNC) BUTTON”, the top left corner of LCD displays an F icon, then press
“(8SET) BUTTON” to enter function menu.
2. Press “UP ARROW” or “DOWN ARROW” button to choose No.8 function item. It shows
“PTT-ID” on LCD.
3. Press “(FUNC) BUTTON” to enter into function menu setup.
4. Press “UP ARROW” or “DOWN ARROW” button to select desired setup. BOT: Start, press [PTT]
button to send a series of DTMF code. EOT: End, release [PTT] button to send a series of DTMF
code. BOTH: Start and End; OFF: PTT ID is turned off.
5. Press “(FUNC) BUTTON” to go back to previous menu. Press “(ESC/M) BUTTON”or “(
*
ENT)
BUTTON” to conrm and exit.