RIDGE RYDER RR50A - Battery Voltage Setup; Display Mode Setup

PAGE 17
DISPLAY MODE SETUP
There are display modes as channel number display, channel frequency+ channel number display
and channel name display, 3 modes in total for option.
1. Press and hold [PF1] button till the transceiver emits “a tone”, and then release it to enter into
background operation.
2. Press “UP ARROW” or “DOWN ARROW” button to choose No.11 function item. It shows
“DSP” on LCD.
3. Press “(FUNC) BUTTON” to enter into function menu setup.
4. Press “UP ARROW” or “DOWN ARROW” button to set desired setup. FREQ: Frequency +
Channel number (Amateur transceiver mode) press ==button to switch into VFO mode. CH: Channel
number (Professional transceiver mode). NAME: Channel name display. When a channel is not
named, LCD displays current frequency and channel number. Otherwise, LCD displays channel
name.
5.Press “(FUNC) BUTTON” to go back to previous menu. Press “(ESC/M) BUTTON”or “(
*
ENT)
BUTTON” to conrm and exit.
The transceiver will allow you to have both the current channel and Primary channel at stand by.
Normally only one channel is available in standby state. This function will allow you to have 2
channels at standby.
1. Press and hold [PF1] button till the transceiver emits “a tone”, and then release it to enter into
background operation.
2. Press “UP ARROW” or “DOWN ARROW” button to choose No.14 function item. It shows
“PRI-CH” on LCD.
3. Press “(FUNC) BUTTON” to enter into function menu setup.
4. Press “UP ARROW” or “DOWN ARROW” button to set desired setup. CH: 001-080
5.Press “(FUNC) BUTTON” to go back to previous menu. Press “(ESC/M) BUTTON”or “(
*
ENT)
BUTTON” to conrm and exit.
1. Press and hold [PF1] button till the transceiver emits “a tone”, and then release it to enter into
background operation.
2. Press “UP ARROW” or “DOWN ARROW” button to choose No.15 function item. It shows
“V-BATT” on LCD.
3. Press “(FUNC) BUTTON” to display remaining battery voltage.
4.Press “(FUNC) BUTTON” to go back to previous menu. Press “(ESC/M) BUTTON”or “(
*
ENT)
BUTTON” to conrm and exit.
PRIMARY CHANNEL SETUP
BATTERY VOLTAGE