PAGE 16
LCD BACKLIGHT SETUP
1. Press and hold [PF1] button till the transceiver emits “a tone”, and then release it to enter into
background operation.
2. Press “UP ARROW” or “DOWN ARROW” button to choose No.8 function item. It shows
“LIGHT” on LCD.
3. Press “(FUNC) BUTTON” to enter into function menu setup.
4. Press “UP ARROW” or “DOWN ARROW” button to set desired setup. AUTO: Automatic, after
enabling the backlight, it lights for a while before quench automatically. OFF: Normally close.
5.Press “(FUNC) BUTTON” to go back to previous menu. Press “(ESC/M) BUTTON”or “(
*
ENT)
BUTTON” to conrm and exit.
LCD BACKLIGHT COLOR SETUP
There are three kinds of backlight color to be optional.
1. Press and hold [PF1] button till the transceiver emits “a tone”, and then release it to enter into
background operation.
2. Press “UP ARROW” or “DOWN ARROW” button to choose No.9 function item. It shows
“COLOUR” on LCD.
3. Press “(FUNC) BUTTON” to enter into function menu setup.
4. Press “UP ARROW” or “DOWN ARROW” button to set desired setup. BLUE: blue backlight.
PURPLE: purple backlight. ORG: orange backlight.
5.Press “(FUNC) BUTTON” to go back to previous menu. Press “(ESC/M) BUTTON”or “(
*
ENT)
BUTTON” to conrm and exit.
SCAN DWELL TIME SETUP
There are three kinds of scan dwell time to be optional.
1. Press and hold [PF1] button till the transceiver emits “a tone”, and then release it to enter into
background operation.
2. Press “UP ARROW” or “DOWN ARROW” button to choose No.10 function item. It shows
“SCANTM” on LCD.
3. Press “(FUNC) BUTTON” to enter into function menu setup.
4. Press “UP ARROW” or “DOWN ARROW” button to set desired dwell time. 5S: Once the radio
receives a matching signal, Scan mode will stop for 5 seconds and then continue scanning.
10S: Once the radio receives a matching signal, Scan mode will stop for 10s and then continue
scanning.
5.Press “(FUNC) BUTTON” to go back to previous menu. Press “(ESC/M) BUTTON”or “(
*
ENT)
BUTTON” to conrm and exit.
To Next Page
Loading...