To Next Page
L
Lynn RosalesOct 26, 2025
What to do if the RIDGID Power Tool cable is kinking or breaking?
- CChristopher HammondOct 26, 2025
If the cable of your RIDGID Power Tool is kinking or breaking, several factors could be at play. First, avoid forcing the cable; let the cutter do the work. Ensure you're using the correct cable for the pipe diameter. Only use reverse if the cable gets caught. Replace worn cables and properly support the cable as per the instructions. Other causes include a faulty FOR/REV switch (replace it), a damaged power cord (replace it), a short circuit in the motor (take it to an authorized service center), a faulty Ground Fault Circuit Interrupter (GFCI) (replace the cord set), moisture in the motor, switch, or plug (take the drain cleaner to an Authorized Service Center), an AUTOFEED full of debris (clean it), an AUTOFEED needing lubrication (lubricate it), or an unevenly distributed cable (pull a...
General
