Need help?Do you have a question about the Riello UPS MASTER HP-UL Series and is the answer not in the manual?
General| Frequency | 50/60 Hz |
|---|---|
| Input Voltage | 400 V (3Ph+N) |
| Output Voltage | 400 V (3Ph+N) |
| Battery Type | VRLA |
| Communication Ports | RS232, USB |
| Dimensions | Varies depending on the model (refer to datasheet) |
| Weight | Varies depending on the model (refer to datasheet) |
| Overload Capability | 125% for 10 minutes, 150% for 1 minute |
| Operating Temperature | 0°C to 40°C |
| Topology | Transformer-free double conversion |
Key safety instructions to save and follow for installation and maintenance of the UPS.
General safety instructions to be followed for operating the equipment.
Illustrates power connection terminals for single input UPS models.
Illustrates power connection terminals for dual input UPS models.
Specifies minimum wire sizes for input, output, bypass, and battery connections.
Details requirements for external overcurrent protection devices and their terminals.
Describes the characteristics required for a GFCI used with the UPS.
Details the EPO function for immediate UPS shutdown and its connection.
Shows schematic diagrams for connecting mains, load, and battery cabinets.
Details the interface board for remote commands, alarms, and EPO connections.
Outlines the procedure for transferring the load to a maintenance bypass.
Details the procedure and interpretation of the battery test function.
Explains how to access and use the customizing menu for parameter adjustments.
Details the sequence to access specific menus using the code 436215.
Covers battery type, capacity, and recharging settings.
Explains how to configure pre-alarm settings for battery discharge.
Explains how to issue the command to turn off the inverter and switch to bypass.
Describes the command for a complete system shutdown.
Covers installation of parallel cards and safety precautions for parallel systems.
Details connecting auxiliary contacts of external bypass and output switches.
Provides guidance on sizing cables for parallel UPS connections.
Explains how to connect parallel UPS units using RJ45 signal cards.
Details internal maintenance requiring trained service personnel and safety precautions.
To Next Page