Why is my Riello UPS beeping continuously and showing codes A54, F50, F51, F52, F55, L50, L51, L52?
This usually means the load on your Riello UPS is too high. Reduce the load to be within 100% of the UPS's capacity, or the user-defined threshold if the code displayed is A54.
What to do if my Riello UPS is operating from battery even though the mains voltage is present?
This could be due to a couple of reasons. First, check if the upstream protection has been triggered and reset it, ensuring there's no output overload. Alternatively, the input voltage may be outside the acceptable range. In this case, the issue depends on the mains; wait for the input mains to return within the correct tolerance. The UPS will automatically switch back to mains operation.
What to do if the display of my Riello UPS does not switch on?
There are several possible reasons why the display isn't turning on. Check the following: * Ensure the general switch on the front panel is pressed. * Verify the battery box connector is properly connected. * Confirm the connection to the electricity mains is secure. * Check for a mains voltage failure (blackout). * See if the upstream protection has been triggered and reset it, while also checking for any output overload.
What to do if my Riello UPS display shows the code A61?
The code A61 indicates that the batteries of your Riello UPS need to be replaced. Replace the battery box to resolve this issue.
Why is my Riello UPS beeping continuously and showing codes F03, F05, F07, F10, F13, F21, F40, F41, F42, F43?
These codes indicate a malfunction of the Riello UPS. If you can remove power from the load, try switching the UPS off and then on again. If the problem persists, it is recommended to contact the support service center.
Why is my Riello UPS display on but the load is not powered?
There are a few potential causes: the UPS might be in standby mode, so press the 'ON' key on the front panel. Alternatively, the Stand-by Off mode could be selected, which only powers loads during a blackout. Finally, check the connection to the load to ensure it's properly connected.
What does it mean when my Riello UPS display shows the code A62?
The code A62 on your Riello UPS means that the battery box is either not present or not correctly connected. Check that the battery box is properly inserted and connected.
What should I do if my Riello UPS does not switch on and shows codes A06 or A08?
These codes indicate that the temperature around the Riello UPS is below 0°C. Make sure the UPS is in an environment where the temperature is above this minimum threshold.
Why is my Riello UPS beeping continuously and showing codes F60, L03, L05, L07, L10, L13, L20, L21, L40, L41, L42, L43?
These codes indicate a verified malfunction of the Riello UPS. If you can safely remove power from the load, switch the UPS off and then on again. If the problem continues, contact the support service center.
What does it mean when my Riello UPS display shows the code A63?
The code A63 indicates that the batteries in your Riello UPS are discharged. The UPS is waiting for the battery voltage to exceed the set threshold. Allow the batteries to recharge, or manually force a start-up by pressing and holding the “ON” key for at least 2 seconds.
General| Output Frequency | 50/60 Hz |
|---|---|
| Form Factor | Tower |
| Power Rating | 10000 VA |
| Output Power Capacity | 10000 W |
| Input Voltage | 220/230/240 VAC |
| Output Voltage | 220/230/240 VAC |
| Battery Type | Sealed Lead Acid |
| Battery Runtime | Varies based on load |
| Communication | RS232, USB |
| Operating Temperature | 0 to 40 °C |
| Efficiency | Up to 95% |
To Next Page