What does it mean when my Riello UPS display shows the code A11?
The code A11 on the Riello UPS display indicates that the input relay is blocked. This fault should not cause any immediate malfunctions. However, if the issue recurs upon restarting the unit, it is advisable to contact the support service center.
Why is my Riello UPS beeping continuously and showing codes F04, L04?
These codes indicate that the temperature of the dissipators inside the Riello UPS is too high. Ensure that the environment where the UPS is located is not exceeding 40°C.
Why is my Riello UPS beeping continuously and showing codes F53, L53?
These codes indicate a fault detected on one or more applications powered by the Riello UPS. Disconnect all the applications and then reconnect them one by one to identify the faulty application.
General| Output Frequency | 50/60 Hz |
|---|---|
| Form Factor | Tower |
| Power Rating | 10000 VA |
| Output Power Capacity | 10000 W |
| Input Voltage | 220/230/240 VAC |
| Output Voltage | 220/230/240 VAC |
| Battery Type | Sealed Lead Acid |
| Battery Runtime | Varies based on load |
| Communication | RS232, USB |
| Operating Temperature | 0 to 40 °C |
| Efficiency | Up to 95% |
To Next Page