Riello 40 FS8 - Preliminary Installation Checks; Permitted Operating Positions

13
20063692
GB
Installation
5.4 Preliminary checks
5.4.1 Control of the supply
5.4.2 Control of burner characteristics
Check the identification label of the burner (Fig. 6), showing:
A the burner model;
B the burner type;
C the cryptographic year of manufacture;
D the serial number;
E the data for electrical supply and the protection level;
F the electrical power consumption;
G the data of the burner's minimum and maximum output pos-
sibilities (see Firing rate)
Warning. The burner output must be within the boiler's firing
rate.
5.5 Operating position
CAUTION
After removing all the packaging, check the integ-
rity of the contents.
In the event of doubt, do not use the burner; con-
tact the supplier.
The packaging elements (cardboard box, clips,
plastic bags, etc.) must not be abandoned as they
are potential sources of danger and pollution; they
should be collected and disposed of in the appro-
priate places.
WARNING
A burner label that has been tampered with, re-
moved or is missing, along with anything else that
prevents the definite identification of the burner
makes any installation or maintenance work diffi-
cult.
WARNING
The figure of the label (Fig. 6) is indicative. Some
of the data may be arranged in a different position.
Fig. 6
20065195
WARNING
 The burner is designed to operate only in
positions 1, 2, 3 and 4 (Fig. 7).
 Installation 1 is preferable, as it is the only
one that allows the maintenance operations
as described in this manual.
 Installations 2, 3 and 4 permit operation but
make maintenance and inspection of the
combustion head more difficult.
DANGER
 Any other position could compromise the cor-
rect operation of the appliance.
 Installation 5 is prohibited for safety reasons.
Fig. 7
20065196
2 3 4 51