Rigol DG1000 Series - Disassemble the Rear Cover

To Next Page

To Previous Page

RIGOL Chapter 1 Disassembly and Assembly

DG1000 Service Guide

1-4

Disassemble the Rear Cover

Figure 1-3 Disassemble the Rear Cover

Part Description:

① 2 screws (M4×8 torx pan head screw, used for fastening the rear cover to the

metal chassis)

Disassembly Steps:

1. Use the T20 screwdriver to remove 2 screws (①) that fasten the rear cover to the

metal chassis.

2. Take off the rear cover gently (Note: Pay attention to the direction of the rear

cover when assembling it, do not turn the rear cover upside down).

Rear Cover

①

Other manuals for Rigol DG1000 Series