Rigol DG1000 Series - Function

DG1000 Command System RIGOL
Programming Guide for DG1000
2-9
FUNCtion
FUNCtion commands are used for setting the output function and their parameters;
selecting carrier wave function in modulation mode; choosing any one from 48 built-in
arbitrary waveforms and 10 user-defined waveforms, or the waveform downloaded to
volatile memory currently.
DG1000 supports following FUNCtion commands:
1. FUNCtion
2. FUNCtion?
3. FUNCtion:USER
4. FUNCtion:USER?
5. FUNCtion:SQUare:DCYCle
6. FUNCtion:SQUare:DCYCle?
7. FUNCtion:RAMP:SYMMetry
8. FUNCtion:RAMP:SYMMetry?
9. FUNCtion:CH2
10. FUNCtion:CH2?
11. FUNCtion:USER:CH2
12. FUNCtion:USER:CH2?
13. FUNCtion:SQUare:DCYCle:CH2
14. FUNCtion:SQUare:DCYCle:CH2?
15. FUNCtion:RAMP:SYMMetry:CH2
16. FUNCtion:RAMP:SYMMetry:CH2?