Rigol DG4000 Series

OUTPut Command Subsystem


The :OUTPut[<n>] commands are used to set and control the output parameters
and state of the channel. <n> is the number of the channel (1 or 2) and if it is
not set, the operation will be executed on CH1 by default.
:OUTPut[<n>]:IMPedance
<ohms>|INFinity|MINimum|MAXimum
:OUTPut[<n>]:IMPedance? [MINimum|MAXimum]
:OUTPut[<n>]:LOAD
<ohms>|INFinity|MINimum|MAXimum
:OUTPut[<n>]:LOAD? [MINimum|MAXimum]
:OUTPut[<n>]:NOISe:SCALe <percent>|MINimum|MAXimum
:OUTPut[<n>]:NOISe:SCALe? [MINimum|MAXimum]
:OUTPut[<n>]:NOISe[:STATe] ON|OFF
:OUTPut[<n>]:NOISe[:STATe]?
:OUTPut[<n>]:POLarity NORMal|INVerted
:OUTPut[<n>]:POLarity?
:OUTPut[<n>][:STATe] ON|OFF
:OUTPut[<n>][:STATe]?
:OUTPut[<n>]:SYNC:POLarity POSitive|NEGative
:OUTPut[<n>]:SYNC:POLarity?
:OUTPut[<n>]:SYNC[:STATe] ON|OFF
:OUTPut[<n>]:SYNC[:STATe]?



