[:SOURce<n>]:FUNCtion:ARB:STEP
Syntax
[:SOURce<n>]:FUNCtion:ARB:STEP
Description
Enable the step-by-step output of arbitrary waveform.
Explanation
In step-by-step output mode, the generator calculates the frequency
(30.517578125 kHz) of the output signal automatically according to the
waveform length (16,384) and sample rate. The generator outputs waveform
point by point at this fixed frequency. The step-by-step output mode can prevent
the loss of important waveform points.
This command is only available when the arbitrary waveform function is
enabled.
To Next Page
Loading...
