Parameter
Name Type
Range
1
Default
<frequency>
Consecutive Real
Number
Refer to the Note
below
1 kHz
Note
1
: different sweep waveforms correspond to different end frequency ranges.
Sine: 1 μHz to 160 MHz
Square: 1 μHz to 50 MHz
Ramp: 1 μHz to 4 MHz
Arb: 1 μHz to 40 MHz (except DC in the built-in waveforms)
Explanation
In the sweep mode, the start frequency, end frequency, center frequency and
frequency span are interrelated and their relations fulfill the following equations.
center frequency = (︱start frequency + end frequency︱) /2
frequency span = end frequency - start frequency
Return Format
The query returns the end frequency in scientific notation.
Example
The command below sets the end frequency to 5 kHz.
:FREQuency:STOP 5000
The query below returns 5.000000E+03.
:FREQuency:STOP?
To Next Page
Loading...
