Explanation
DG4000 supports state copy or waveform copy between its two channels,
namely copy the state (parameters and output configuration) or arbitrary
waveform parameters of one channel to the other or swap the states of the two
channels.
State includes waveform (except volatile waveform) and waveform parameters
(such as frequency and amplitude), functions (such as modulation, sweep and
burst) as well as output configurations (such as sync, impedance and polarity) of
the channel.
The channel copy function is not available in coupling mode.
Example
The command below copies the configuration state of CH1 to CH2.
:SYSTem:CSCopy CH1,CH2
To Next Page
Loading...
