Explanation
Each time, 1 to 16384 (16k) points can be downloaded.
-1 and 1 correspond to the maximum and minimum of the waveform
respectively (assume that the offset is set to 0). For example, when the
amplitude is set to 5 Vpp, 1 corresponds to 2.5 V and -1 corresponds to -2.5 V.
This command will overwrite the previous waveform in the volatile memory
without generating any error.
After the command is sent, the instrument will switch the current channel to
output volatile waveform automatically and modify the interpolation mode and
the number of editable points at the same time. The data downloaded using this
command can be edited on the instrument.
To Next Page
Loading...
