Rigol DG800 Series Programming Guide

Chapter 1 Programming Overview RIGOL
DG800 Programming Guide 1-3
3. Check whether the connection is successful
Run Ultra Sigma, and then search for the resources and right-click the resource name. Select "SCPI
Panel Control" to open the SCPI command control panel. Input a correct command in the pop-up SCPI
control panel and click
and in sequence or directly click
to check whether the connection is successful, as shown in the figure below (the
USB interface is taken as an example).

Rigol DG800 Series Specifications

General

Brand	Rigol
Model	DG800 Series
Category	Laboratory Equipment
Language	English