Rigol DG800 Series - Source Commands

RIGOL Chapter 2 Command System
2-50 DG800 Programming Guide
:SOURce Commands
The :SOURce commands are used to set and query the channel parameters, the related parameters of the
modulation, sweep, and burst functions, the coupling and waveform combination functions as well as
enabling or disabling the corresponding function.
The frequency ranges available for different models and different waveforms of DG800 series are as shown
in the table below.
Table 2-1 Frequency Range of Different Models and Different Waveforms of DG800 Series
Frequency
Characteristics
DG812/DG811 DG822/G821 DG832/DG831
Sine
1 μHz to 10 MHz
1 μHz to 25 MHz
1 μHz to 35 MHz
Square
1 μHz to 5 MHz
1 μHz to 10 MHz
1 μHz to 10 MHz
Ramp 1 μHz to 200 kHz 1 μHz to 500 kHz 1 μHz to 1 MHz
Pulse
1 μHz to 5 MHz
1 μHz to 10 MHz
1 μHz to 10 MHz
Harmonic 1 μHz to 5 MHz 1 μHz to 10 MHz 1 μHz to 15 MHz
Noise (-3 dB) 100MHz Bandwidth
Arbitrary
Waveform
1 μHz to 5 MHz 1 μHz to 10 MHz 1 μHz to 10 MHz
Dual-tone
1 μHz to 10 MHz
1 μHz to 20 MHz
1 μHz to 20 MHz
PRBS
2 kbps to 10 Mbps
2 kbps to 20 Mbps
2 kbps to 30 Mbps
RS232
baud rate range: 9600, 14400, 19200, 38400, 57600, 115200, 128000, 230400
Sequence
2 k to 30 MSa/s
Command List:
 :SOURce:APPLy
 :SOURce:BURSt
 :SOURce:FREQuency
 :SOURce:FUNCtion
 :SOURce:HARMonic
 :SOURce:MARKer
 :SOURce[:MOD]:AM
 :SOURce[:MOD]:ASKey
 :SOURce[:MOD]:FM
 :SOURce[:MOD]:FSKey
 :SOURce[:MOD]:PM
 :SOURce[:MOD]:PSKey
 :SOURce[:MOD]:PWM
 :SOURce:MOD
 :SOURce:PERiod
 :SOURce:PHASe
 :SOURce:PULSe
 :SOURce:SUM
 :SOURce:SWEep