Rigol DG800 Series - IEEE488.2 Common Commands

RIGOL Chapter 2 Command System
2-22 DG800 Programming Guide
IEEE488.2 Common Commands
The IEEE488.2 standard defines a series of common commands that can be used to execute various
functions, such as the reset, self-test, and status operations.
Command List:
 *CLS
 *ESE
 *ESR?
 *IDN?
 *OPC
 *OPT?
 *PSC
 *RCL
 *RST
 *SAV
 *SRE
 *STB?
 *TRG
 *WAI
*CLS
Syntax
*CLS
Description
Clears the event registers in all the register sets and clears the error queue.
*ESE
Syntax
*ESE <value>
*ESE?
Description
Enables the bits in the standard event register to be reported to the status byte register.
Queries the bit enabled in the standard event register.
Parameter
Name
Type
Range
Default
<value> Integer
Refer to
"
Remarks
"
0
Remarks
 The parameter <value> is a decimal value. It corresponds to the binary-weighted sum of the bits to be
reported to the status byte register in the standard event register.
 When the parameter <value> is set to 0, you can run the command to clear the enable register part of