Rigol DG800 Series - Page 168

RIGOL Chapter 2 Command System
2-154 DG800 Programming Guide
:SYSTem:PRESet:SAVe
Syntax
:SYSTem:PRESet:SAVe {USER1|USER2|USER3|USER4|USER5|USER6|USER7|USER8|USER9|USER10}
Description
Saves the current system status to the specified user storage location (USER1 to USER10) in the internal
memory of the instrument.
Parameter
Name
Type
Range
Default
{USER1|USER2|USER3|USER4|
USER5|USER6|USER7|USER8|
USER9|USER10}
Discrete
USER1|USER2|USER3|USER4|
USER5|USER6|USER7|USER8|
USER9|USER10
None
Example
:SYSTem:PRESet:SAVe USER1 /*Saves the system status to the user storage location 1 in the internal
memory of the instrument.*/
:SYSTem:PRESet[:STATe]?
Syntax
:SYSTem:PRESet[:STATe]?
Description
Queries user-defined 10 system status names.
Return Format
The query returns 10 system status names. If User n saves the current system status, then the query
returns the current system status name. For example, "Default","","User2","","","","","","","","".
:SYSTem:ROSCillator:SOURce
Syntax
:SYSTem:ROSCillator:SOURce {INTernal|EXTernal}
:SYSTem:ROSCillator:SOURce?
Description
Sets the system clock source to internal source (INTernal) or external source (EXTernal).
Queries the system clock source type.
Parameter
Name
Type
Range
Default
{INTernal|EXTernal}
Discrete
INTernal|EXTernal
INTernal
Remarks
 DG800 provides an internal 10 MHz clock source and receives the external clock source from the
rear-panel [10MHz In/Out] connector. It can also output clock source from the [10MHz In/Out]
connector for other devices.
 If "External" is selected, the instrument will detect whether a valid external clock signal is input from
the rear-panel [10MHz In/Out] connector. If no valid clock source is detected, a prompt message is
displayed, and the clock source will be switched to Internal.
 You can synchronize two or multiple instruments by setting the clock source.
 Synchronization between two instruments: