EasyManua.ls Logo

Rigol DG800 Series - Page 59

Rigol DG800 Series
209 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2 Command System RIGOL
DG800 Programming Guide 2-45
Return Format
The query returns ON or OFF.
Example
:OUTP1? /*Queries the output status of CH1 and the query returns OFF.*/
:OUTP1 ON /*Enables the output of CH1.*/
:OUTP1? /*Queries the output status of CH1 and the query returns ON.*/
:OUTPut[<n>]:SYNC:POLarity
Syntax
:OUTPut[<n>]:SYNC:POLarity {POSitive|NEGative}
:OUTPut[<n>]:SYNC:POLarity?
Description
Sets the output polarity of the sync signal on the rear-panel [Sync/Ext Mod/Trig/FSK] connector of the
specified channel to normal (POSitive) or inverted (NEGative).
Queries the output polarity of the sync signal on the rear-panel [Sync/Ext Mod/Trig/FSK] connector of
the specified channel.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
{POSitive|NEGative}
Discrete
POSitive|NEGative
POSitive
Remarks
When [<n>] is omitted, the commands set and query the related parameters of CH1 by default.
The output polarity of the sync signal refers to that the sync signal on the rear-panel [Sync/Ext
Mod/Trig/FSK] connector of the specified channel is normal (POSitive) output or inverted (NEGative)
output. In the normal mode, the instrument outputs the normal sync signal; in the inverted mode, the
sync signal is inverted and then output.
After the waveform is inverted (
:OUTPut[<n>]:POLarity), the sync signal related to the waveform is
not inverted.
Return Format
The query returns POS or NEG.
Example
:OUTP1:SYNC:POL POS /*Sets the output polarity of the sync signal on the rear-panel [CH1/Sync/Ext
Mod/Trig/FSK] connector to POSitive.*/
:OUTP1:SYNC:POL? /*Queries the output polarity of the sync signal on the rear-panel
[CH1/Sync/Ext Mod/Trig/FSK] connector, and the query returns POS.*/
:OUTPut[<n>]:SYNC[:STATe]
Syntax
:OUTPut[<n>]:SYNC[:STATe] {ON|1|OFF|0}
:OUTPut[<n>]:SYNC[:STATe]?
Description
Enables or disables the sync signal output from the rear-panel [Sync/Ext Mod/Trig/FSK] connector of
the specified channel.
Queries the output status of the sync signal output from the rear-panel [Sync/Ext Mod/Trig/FSK]
connector of the specified channel.

Other manuals for Rigol DG800 Series

Related product manuals