Rigol DG800 Series - Page 61

Chapter 2 Command System RIGOL
DG800 Programming Guide 2-47
:OUTPut[<n>]:VOLLimit:LOW
Syntax
:OUTPut[<n>]:VOLLimit:LOW <amp>
:OUTPut[<n>]:VOLLimit:LOW?
Description
Sets the low level amplitude of voltage limit.
Queries the low level amplitude of voltage limit.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
<amp>
Real
Refer to "Remarks".
0 V
Remarks
 When [<n>] is omitted, the commands set and query the related parameters of CH1 by default.
 The range of low level limit depends on the current amplitude and offset settings.
Return Format
The query returns the low level limit value in scientific notation with 7 effective digits. For example,
-1.000000E+00, indicating that the high level limit value is -1 V.
Example
:OUTP1:VOLLimit:LOW /*Sets the low level amplitude of voltage limit of CH1 to -1 V.*/
:OUTP1:VOLLimit:LOW? /*Queries the low level amplitude of voltage limit of CH1 and returns
-1.000000E+00.*/
:OUTPut[<n>]:VOLLimit[:STATe]
Syntax
:OUTPut[<n>]:VOLLimit[:STATe] {ON|1|OFF|0}
:OUTPut[<n>]:VOLLimit[:STATe]?
Description
Enables or disables the voltage limit.
Queries the on/off status of the voltage limit.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
{ON|1|OFF|0}
Bool
ON|1|OFF|0
ON
Remarks
When [<n>] is omitted, the commands set and query the related parameters of CH1 by default.
Return Format
The query returns ON or OFF.
Example
:OUTP1:VOLLimit? /*Queries the on/off status of the voltage limit of CH1 and the query returns OFF.*/
:OUTP1:VOLLimit ON /*Enables the voltage limit of CH1.*/
:OUTP1:VOLLimit? /*Queries the on/off status of the voltage limit of CH1 and the query returns ON.*/