Rigol DG800 Series - Page 76

RIGOL Chapter 2 Command System
2-62 DG800 Programming Guide
[:SOURce[<n>]]:BURSt[:STATe]
Syntax
[:SOURce[<n>]]:BURSt[:STATe] {ON|1|OFF|0}
[:SOURce[<n>]]:BURSt[:STATe]?
Description
Enables or disables the burst function of the specified channel.
Queries the on/off status of the burst function of the specified channel.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
{ON|1|OFF|0}
Bool
ON|1|OFF|0
OFF
Remarks
 DG800 can output the waveforms with a specified number of cycles (Burst) from a single channel or
from dual channels at the same time. After the Burst function is enabled, the modulation or the sweep
function will automatically be disabled (if enabled currently). At this time, the generator will output
burst waveform from the corresponding channel (if currently turned on) according to the current
configuration
 To avoid a large quantity of waveform changes, please enable the burst function after configuring the
other burst parameters.
 When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related parameters of CH1 by default.
Return Format
The query returns ON or OFF.
Example
:SOUR1:BURS ON /*Enables the burst function of CH1.*/
:SOUR1:BURS? /*Queries the on/off status of the Burst function of CH1 and the query returns ON.*/
[:SOURce[<n>]]:BURSt:TDELay
Syntax
[:SOURce[<n>]]:BURSt:TDELay {<delay>|MINimum|MAXimum}
[:SOURce[<n>]]:BURSt:TDELay? [MINimum|MAXimum]
Description
Sets the burst delay of the N cycle burst or Infinite burst of the specified channel.
Queries the burst delay of the N cycle burst or Infinite burst of the specified channel.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
<delay>
Real
Refer to "Remarks".
0 s
Remarks
 Burst delay is only available for N cycle and Infinite burst mode (
[:SOURce[<n>]]:BURSt:MODE). It is
defined as the duration from the time when the generator receives the trigger signal to the time when
it starts to output the N Cycle (or Infinite) burst.
 For the N cycle burst or Infinite burst in the external trigger or manual trigger mode
(
[:SOURce[<n>]]:BURSt:TRIGger:SOURce), the range of <delay> is 0 s to 100 s.
 For the N cycle burst in the internal trigger mode, the range of <delay> is 0 s to
(
2us−×−
cyclewaveformburst
NPP
) and its range should be smaller than or equal to 100 s.