RIGOL Chapter 3 Remote Control
3-2 DP800 User’s Guide
Remote Control via USB
1. Connect the device
Connect the USB DEVICE interface at the rear panel of the power supply with
your PC using a USB cable.
2. Install the USB driver
This power supply is a USB-TMC device. After you connect the power supply to
the PC and turn both on for the first time (the power supply is automatically
configured to USB interface), the Found New Hardware Wizard as shown in the
figure below is displayed on the PC. Please install the "USB Test and
Measurement Device (IVI)" driver following the directions in the wizard. The
steps are as follows.
To Next Page
Loading...
Need help?
General
