Rigol DP822A User Manual

RIGOL Chapter 2 Front Panel Operations
2-60 DP800 User’s Guide
Print
You can store the screen content as a picture file in the USB storage device.
Note: DP800 only supports the flash memory USB storage device of FAT32 format.
1. Insert a USB storage device into the USB HOST interface at the rear panel of the
instrument. When the USB storage device is detected,
is displayed in the
status bar on the screen and the corresponding prompt message is displayed.
2. Press Utility  Print Set  Print and the countdown label (5s) is displayed at
the left of the status bar. Switch the instrument to the desired interface within 5s
and the instrument stores the screen content in "*.BMP" format in the USB
storage device 5s later after you press Print. After that, the corresponding
prompt message is displayed.
When no USB storage device is currently detected, press Print and the prompt
message "USB storage device does not exist." will be displayed.

Rigol DP822A Specifications

General

Brand	Rigol
Model	DP822A
Category	Power Supply
Language	English