Rigol DP832 Manual

RIGOL
4 DP800 Quick Guide
1. LCD
3.5 inches TFT display. It is used to display system parameter settings, system
output state, menu options, prompt messages, etc.
2. Channel (Range) Selection and Output Switch
For the multi-channel model, the function of this part is channel selection and
output switch. For the single-channel model, the function of this part is range
selection and output switch.
Multi-channel models (take DP832 as an example):
Press this key to select CH1 as the current channel and you can set
the parameters of this channel, such as voltage, current and
overvoltage/overcurrent protection.
Press this key to select CH2 as the current channel and you can set
the parameters of this channel, such as voltage, current and
overvoltage/overcurrent protection.
Press this key to select CH3 as the current channel and you can set
the parameters of this channel, such as voltage, current and
overvoltage/overcurrent protection.
Press this key to enable or disable the output of the corresponding
channel.
Press this key and the prompt message asking whether to enable
the outputs of all the channels will be displayed. Press OK to enable
the outputs of all the channels. Pressing this key again will disable
the outputs of all the channels.

Rigol DP832 Specifications

General

Number of Outputs	3
Output Voltage Range CH1/CH2	0-30V
Output Voltage Range CH3	0-5V
Output Current Range CH1/CH2	0-3A
Output Current Range CH3	0-3A
Total Power	195 W
Power per Channel CH1/CH2	90 W
Power per Channel CH3	15 W
Voltage Resolution	1 mV
Current Resolution	1 mA
Interfaces	USB, RS232
Display	3.5 inch TFT LCD