RIGOL
User’s Guide for DS1000B Series
2-1
Chapter 2 Operating Your Oscilloscope
By now, a user should understand the VERTICAL, HORIZONTAL and TRIGGER
control systems and know how to determine the system setup from the status bar of
a DS1000B series digital oscilloscope. This chapter will go through all groups of
front-panel buttons, knobs and menus; and further the knowledge of the operation
by hints in this guide. It is strongly recommended to perform all of the following
exercises to get the most of the powerful measurement capabilities of the
oscilloscope.
This chapter covers the following topics:
To Set up the Vertical System
(CH1, CH2, CH3, CH4, MATH, REF ,
Vertical , Vertical )
To Set up the Horizontal System (MENU, Horizontal
,
Horizontal )
To Set up the Trigger System (MODE,
, MENU, FORCE, 50%)
To Set up the Sampling System (Acquire)
To Set up the Display System (Display)
To Store and Recall (Storage)
To Set up the Utility (Utility)
To Measure Automatically (Measure)
To Measure with Cursors (Cursor)
To Use Run Control Buttons (Auto, Run/Stop, Single)
Please read this chapter carefully to get more functions and operations about
DS1000B series oscilloscopes.
To Next Page
Loading...
