Rigol DS1000B Series User Manual

RIGOL
User’s Guide for DS1000B series
2-8
2. To set up the channel bandwidth limit
Take Channel 1 for an example, input a signal containing high frequency
component. Press CH1→BW Limit→OFF, to set up bandwidth limit to “OFF”
status. The oscilloscope is set to full bandwidth and passing the high frequency
component in the signal.
Figure 2-6 Turn off the BW limit
Press CH1→BW Limit→ON, to set up bandwidth limit to “ON” status. It will
restraint the frequency component higher than 20MHz.
Figure 2-7 Turn on the BW limit
Turn off the
BW Limit
Mark of
BW limit
20MHz
BW limit

Rigol DS1000B Series Specifications

General

Brand	Rigol
Model	DS1000B Series
Category	Test Equipment
Language	English