Rigol DS1104B - Page 111

Command Systems RIGOL
Programming Guide for DS1000B Series
2-99
Function:
The command recalls the waveform or setup data from internal flash according
to storage type.
4. :SAVERECALL:SAVe
Command Format:
:SAVERECALL:SAVE
Function:
The command saves the waveform or setup to internal flash according to
storage type.
5. :SAVe:IMAGe:STARt
Command Format:
:SAVE:IMAGe:STARt <file_spec>
Function:
The command saves the image. The <file_spec> is the file name, which is
composed of double quotation marks and ASCII characters, also, the file name
length within the double quotation marks must less than 26 characters.
NOTE: The system will add the file format suffix with 4 characters automatically, which are
not included in 26 characters.
6. :SAVe:IMAGe:FACTors
Command Format:
:SAVE:IMAGe:FACTors {{1|ON}|{0|OFF}}
:SAVE:IMAGe:FACTors?
Function:
The command sets the saving function of system parameters on or off. The
function indicates to save a file which records all system parameters while
saving image.