Rigol DS1104B - Page 113

Command Systems RIGOL
Programming Guide for DS1000B Series
2-101
9. :SAVe:SETup:STARt
Command Format:
:SAVE:SETup:STARt <file_spec>
Function:
The command starts the saving setup function. If the waveforms are in internal
flash, the <file_spec> is composed of integers among 0~9; if in external
storage medium, the <file_spec> will be the file name, which is composed of
double quotation marks and ASCII characters, also, the file name length within
the double quotation marks must less than 26 characters.
NOTE: The system will add the file format suffix with 4 characters automatically, which are
not included in 26 characters.
10. :SAVe:CSV:STARt
Command Format:
:SAVE:CSV:STARt <file_spec>]
Function:
The command sets the saving function of CSV file on. CSV file can be saved in
external storage medium. The <file_spec> will be the file name, which is
composed of double quotation marks and ASCII characters, also, the file name
length within the double quotation marks must less than 26 characters.
NOTE: The system will add the file format suffix with 4 characters automatically, which are
not included in 26 characters.
11. :RECall:WAVeform:STARt
Command Format:
:RECAll:WAVeform:STARt <file_spec>
Function:
The command sets the recalling waveform function on. If the waveforms are in
internal flash, the <file_spec> is composed of integers among 0~9; if in
external storage medium, the <file_spec> will be the file name, which is
composed of double quotation marks and ASCII characters, also, the file name