Need help?Do you have a question about the Rigol DS2302A and is the answer not in the manual?
General| Brand | Rigol |
|---|---|
| Model | DS2302A |
| Category | Test Equipment |
| Language | English |
Overview of essential safety precautions before operating the instrument to avoid personal injury or damage.
Explanation of safety terms (Danger, Warning, Caution) and symbols used on the product and in the manual.
Covers adjusting supporting legs, connecting power supply, and performing power-on inspection.
Explains how to connect probes and perform initial function checks, including probe compensation.
Guides on enabling analog channels, setting channel coupling modes (DC, AC, GND).
Covers adjusting vertical scale for coarse/fine settings and expanding/compressing signals vertically.
Explains using delayed sweep to enlarge specific waveform sections for detailed viewing.
Guides on setting horizontal time base scale and reference points for waveform adjustments.
Describes acquisition modes like Normal, Average, Peak Detect, and High Resolution for waveform sampling.
Lists trigger sources, explains modes (Auto, Normal, Single), and details trigger coupling types.
Explains trigger holdoff time settings and how to enable/disable noise rejection.
Lists and describes various trigger types including Edge, Pulse, Runt, Serial Bus (RS232, I2C, SPI, CAN).
Details performing Add, Subtract, Multiply, Divide, FFT, Digital Filter, Logic, and Advanced operations.
Explains automatic measurements of 29 waveform parameters like Period, Frequency, Rise Time, Fall Time.
Details setting logic thresholds for digital channels and configuring digital buses for data display.
Introduces protocol analysis for Parallel, RS232, I2C, SPI, CAN, and basic setup procedures.
Details configuration for RS232, I2C, SPI, and CAN serial bus protocol decoding and error analysis.
Covers enabling the pass/fail test function and defining mask ranges for waveform analysis.
Addresses common problems like dark screen, no waveform, unstable display, and USB connection failures.
To Next Page
