Chapter 7 Digital Channel RIGOL
MSO2000A/DS2000A User Guide 7-1
Chapter 7 Digital Channel
MSO2000A series mixed signal digital oscilloscope provides 2 analog channels as well
as 16 digital channels. For the digital channels, the oscilloscope compares the
voltages acquired in each sample with the preset logic threshold. If the voltage of the
sample point is greater than the logic threshold, it will be stored as logic 1; otherwise,
it will be stored as logic 0. The oscilloscope displays the logic 1 and logic 0 in figure
form for users to easily detect and analyze the errors in the circuit design (hardware
design and software design). This chapter introduces how to use the digital channels
of MSO2000A mixed signal digital oscilloscope.
Before using the digital channels, connect the oscilloscope and the device under test
by using RPL2316 logic probe provided in the accessories. For the using method of
the logic probe, refer to the
RPL2316 Logic Probe User Guide
.
The contents of this chapter:
To Select the Digital Channel
To Move the Digital Channel
To Turn on/off the Digital Channel
Group Set
To Set the Waveform Display Size
Reorder Setting
To Set the Threshold
To Use the Digital Bus
To Set the Label
Digital Channel Delay Calibration
To Next Page
Loading...
