Rigol DS7034 - Measure Commands; Measure:source

Chapter 2 Command System RIGOL
MSO7000/DS7000 Programming Guide 2-107
:MEASure Commands
The :MEASure commands are used to set and query the relevant parameters for measurement.
Command List:
 :MEASure:SOURce
 :MEASure:COUNter:ENABle
 :MEASure:COUNter:SOURce
 :MEASure:COUNter:VALue?
 :MEASure:CLEar
 :MEASure:THReshold:SOURce
 :MEASure:THReshold:DEFault
 :MEASure:MODE
 :MEASure:AMSource
 :MEASure:SETup:MAX
 :MEASure:SETup:MID
 :MEASure:SETup:MIN
 :MEASure:SETup:PSA
 :MEASure:SETup:PSB
 :MEASure:SETup:DSA
 :MEASure:SETup:DSB
 :MEASure:STATistic:DISPlay
 :MEASure:STATistic:RESet
 :MEASure:STATistic:ITEM
 :MEASure:ITEM
 :MEASure:AREA
 :MEASure:CREGion:CAX
 :MEASure:CREGion:CBX
 :MEASure:CATegory
:MEASure:SOURce
Syntax
:MEASure:SOURce <sour>
:MEASure:SOURce?
Description
Sets or queries the channel source of the current measurement parameter.
Parameter
Name
Type
Range
Default
<sour>
Discrete
{D0|D1|D2|D3|D4|D5|D6|D7|D8|
D9|D10|D11|D12|D13|D14|D15|
CHANnel1|CHANnel2|CHANnel3|CHANnel4|
MATH1|MATH2|MATH3|MATH4}
CHANnel1