Rigol DS7034 - :TRIGger Commands

RIGOL Chapter 2 Command System
2-162 MSO7000/DS7000 Programming Guide
:TRIGger Commands
The :TRIGger commands are used to set the trigger system of the oscilloscope.
Command List:
 :TRIGger:MODE
 :TRIGger:COUPling
 :TRIGger:STATus?
 :TRIGger:SWEep
 :TRIGger:HOLDoff
 :TRIGger:NREJect
 :TRIGger:EDGE
 :TRIGger:PULSe
 :TRIGger:SLOPe
 :TRIGger:VIDeo
 :TRIGger:PATTern
 :TRIGger:DURATion
 :TRIGger:TIMeout
 :TRIGger:RUNT
 :TRIGger:WINDows
 :TRIGger:DELay
 :TRIGger:SHOLd
 :TRIGger:NEDGe
 :TRIGger:RS232 (Option)
 :TRIGger:IIC (Option)
 :TRIGger:CAN (Option)
 :TRIGger:SPI (Option)
 :TRIGger:FLEXray (Option)
 :TRIGger:IIS (Option)
 :TRIGger:LIN (Option)
 :TRIGger:M1553 (Option)