Rigol MSO1074Z Programming Guide

Chapter 2 Command System RIGOL
MSO1000Z/DS1000Z Programming Guide 2-1
Chapter 2 Command System
This chapter introduces the syntax, function, parameter, and using instruction of each MSO1000Z/DS1000Z
command.
Main topics of this chapter:
 :AUToscale
 :CLEar
 :RUN
 :STOP
 :SINGle
 :TFORce
 :ACQuire Commands
 :CALibrate Commands
 :CHANnel<n> Commands
 :CURSor Commands
 :DECoder Commands
 :DISPlay Commands
 :ETABle Commands
 :FUNCtion Commands
 IEEE488.2 Common Commands
 :LA Commands
 :MATH Commands
 :MASK Commands
 :MEASure Commands
 :REFerence Commands
 [:SOURce[<n>]] Commands
 :STORage Commands
 :SYSTem Commands
 [:TRACe[<n>]] Commands
 :TIMebase Commands
 :TRIGger Commands
 :WAVeform Commands
Note:
1. Unless otherwise noted, this manual takes MSO1104Z-S as an example to introduce the commands.
2. Unless otherwise noted, the descriptions and commands related to the digital channels in this manual
are only applicable to MSO1000Z and DS1000Z Plus with the MSO upgrade option.
3. For parameter setting commands (for example, the time, frequency, and amplitude), the oscilloscope
can only accept numbers and set the parameters using the default units; it cannot recognize the units
sent with the parameters. For the default unit of each parameter, please refer to the description in each
command in the following introductions.

Rigol MSO1074Z Specifications

General

Brand	Rigol
Model	MSO1074Z
Category	Test Equipment
Language	English