Motion Detector.
Motion Detectors are designed to be smart. They
allow you to move freely through your home while
also being ready to detect movement through
rooms and hallways when armed.
When working normally, Motion Detectors detect
motion constantly, but will only notify you to the first
detection. After three to four minutes of no activity,
it will be ready to notify you again. You can arm your
Alarm in Away Mode during this period, and it will
detect intruders.
In Test Mode, motion is constantly detected, and
will notify you about every seconds. Test Mode is
designed to help you test for blind spots, pets, and
other environmental triggers.
Where should you place your Motion Detector?
• Install . m (') above the floor, if possible.
• Install in a corner or on a flat wall
(see illustrations).
• Choose a location with a clear line of sight, with
no obstacles or blind spots.
To avoid false alarms:
• The Detector should not face a heat source such
as a stove, fireplace or windows with direct sun.
• Use the app to adjust motion sensitivity to
accommodate many pets.
• Make sure your pets can’t get close to the Motion
Detector by climbing on furniture.
• The Detector should be armed in Away Mode,
but disarmed in Home Mode. This is the
default setting.
• Don't place your Ring Alarm system in an
unheated building, such as a garage or shed.
Install steps:
. Connect
To connect your Motion Detector, pull the
battery tab.
. Configure
Using the app, decide where you will place your
Motion Detector; then give it a unique name and
assign it to a room.
. Install
Locate the bracket for the back of the Detector
in the accessory bag. Securely mount the bracket
using the included tape or screws. Snap the
Motion Detector onto its bracket.
Motion Detector in a corner
Motion Detector on a wall
1312
To Next Page
Loading...
Need help?
General
