Need help?Do you have a question about the ring Contact Sensor and is the answer not in the manual?
General| Type | Contact Sensor |
|---|---|
| Power Source | Battery |
| Battery Type | CR2032 |
| Power | 3V |
| Battery Life | Up to 3 years |
| Connectivity | Z-Wave |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Compatibility | Ring Alarm |
| Range | Up to 250 feet (line of sight) |
Illustrates the parts of the Ring Contact Sensor: sensor, LED ring, and magnet.
Guides users to initiate setup in the Ring app by selecting 'Set Up a Device' near the Base Station.
Details activating the sensor by pulling the battery tab and pairing it by scanning a QR code or entering an S2 PIN.
Explains how to track the connection status via the sensor's LED ring patterns.
Instructs users to open and close the sensor to ensure the app correctly registers its status.
Guides users to temporarily position the sensor on the door or window before permanent installation.
Details how to align the sensor and magnet, specifying the maximum allowed gap of 1/2 inch.
Instructs on the final mounting of the sensor using the provided bracket, tape, or screws.
Advises users to review the Ring app for sensor activity history to confirm correct operation.
Provides instructions on how to replace the sensor's battery, including accessing the battery compartment.
To Next Page